SUBWOOFERS

Revel B112

Revel B112 Revel B112 Revel B112 Revel B112 Revel B112
Revel B112
Revel B112 Revel B112 Revel B112 Revel B112
Introduction

The B112 and B110 feature 12-inch and 10-inch versions, respectively, of a brand-new low-frequency transducer that has been designed specifically for use in these two subwoofer models. The primary design goal for this new driver was to produce very low frequencies at extremely high SPL (sound-pressure levels) while at the same time maintaining extremely low distortion, requirements that usually remain mutually exclusive. This new unit maintains a precise engineering balance between the voice coil, spider and surround that produces linear motion of all three for lower distortion by incorporating CAD/FEA optimized high-linearity motor geometry:

  • The extremely long (50mm) two-layer copper voice coil gives this transducer a very high Xmax, dramatically increasing output. A fiberglass voice coil former helps the voice coil withstand high temperatures, reducing power compression and helping increase output. A cardboard spacer added at the top of the voice coil former maintains motor geometry, creates a solid attachment joint and prevents deformation of the voice coil at high outputs. The spacer also eliminates the typical single fulcrum point between the spider and cone on the voice coil former, minimizing voice coil rocking modes during hi-power operation.
  • A high-temperature nomex spider features a progressive roll design that evenly distributes mechanical stress, helping keep the cone’s motion linear during high excursion operation.
  • A nitril/butylene rubber surround uses patented Plus One® technology that increases the transducer’s radiating area (Sd), increasing volume displacement and output.
The coated cellulose/pulp cone and dustcap assembly is vented under the dustcap to aid in the exchange of air, which reduces acoustic losses and increases output. The transducer’s magnet assembly features a triple-stacked vented ceramic 5 magnet with flared vents that reduce turbulence, which improves airflow, increases output and reduces distortion. Dual symmetrical magnet shorting rings and an extended top pole create a symmetrical magnetic gap field that increases power handling and reduces power compression further increasing output. A 15mm-thick top plate improves heat and flux distribution for lower distortion. The cast aluminum frame is fully vented to minimize acoustic losses caused by excessive back pressure. This frame also maintains dimensional stability and precise mechanical tolerances, allowing the transducer to be manufactured and assembled to a high degree of precision.

Features
Specifications
SPECIFICATIONS

Description

1000-watt 12" Powered Subwoofer

Amplifier Power

1000W

Drive Components

12” (30 cm) Aluminum Cone, Cast-frame Woofer

Input Connections

Line-level XLR and RCA In/Out

Features

DSP EQ

Height

17.8" (45.2 cm)

Width

15.7" (39.9 cm)

Depth

16.5" (41.9 cm)

Weight

Net Weight: 70 lb (32 kg)

Finishes

Piano Black or High Gloss Walnut

CONTACT US
Let us follow up
with you
Our office hours are 9:30am-5:30pm weekdays — please drop by, call us or fill in the contact form so we can reply to you shortly.

1998 NE 150th Street, North Miami,
FL 33181 USA
Phone: (305) 573-7339
Fax: (305) 573-8101
E-mail:
Your message was sent succesfully!

Your e-mail

Your message