QSC DCP 300

Features

Digital input for up to 16 channels of audio
Networked audio I/O via CobraNet™
Network control and monitoring via SNMP
Serial automation control via RS-232
Analog Inputs for film processors, non-sync and mic/line
Master volume and full 1/3 octave graphic EQ on all channels
Booth monitor with touch screen control for easy operation
Digital loudspeaker crossovers
Three or five screen channels - passive and 2-, 3-, or 4-way crossovers
Compatible with all existing DCA amplifiers- thousands of DCA equipped screens are ready for full network monitoring and control
Dual power supplies with load sharing for seamless operation in the event of failure
SD memory card for quick unit swap - restores all settings
Multiple bypass modes routes audio around failed components to insure that the show will go on
DCP Manager and DCPNet PC-based application for set-up, control and monitoring
DCP Connect mobile app for iPhone and Android provide control and monitoring capabilities via smart phone

DSP presets for DCS speakers for great "out of box" performance and reduced set-up time
Crossovers support active 2-, 3-, and 4-way systems as well as passive systems
Easily integrates with existing film processors for dual film/digital projection systems
CobraNet offers digital non-sync routing and future expansion capability
Continued development of software and firmware will add new capabilities to the existing hardware with easy firmware updates
The DCP 300 is designed expressly for the needs of D-Cinema sound systems

Introduction

Specifications

SPECIFICATIONS

D-Cinema input group 1	DB-25: AES3/EBU channels 1-8
D-Cinema input group 2	DB-25: AES3/EBU channels 9-16
Main analog input	DB-25: Analog audio channels 1-8
Dataport outputs	HD-15 (14): QSC amplifier interface
Automation inputs	6-pin Euro-style (two) TTL compatible dry contact closure
Serial Control	DB-9 RS-232 serial interface
Output impedance	50 ohms
Nominal output level	-11.8 dBu (200 mVrms)

Loading requirements	RMIN = 2 kΩ, CMAX = 4 nF
Protocol	CobraNet version 2 protocol
Data rate	100 Mbps (Fast Ethernet)
Ports	1 primary, 1 backup (auto-failover)
Connection requirements	Cat-5 UTP cable or better (100 m maximum length), direct connection to wired network switch ports only, dedicated LAN or VLAN
Line voltage requirements	100–240 VAC, 50/60 Hz
Dimensions (H/W/D)	5.25” × 19” × 15.2” (133 mm × 483 mm × 386 mm)
Weight	16.6 lb (7.5 kg)