The Crestron® MP-AMP30 provides a convenient, low-cost audio amplifier solution for a variety of applications. A perfect complement to the entire Media Presentation line from Crestron, it features a compact surface-mountable design that installs virtually anywhere without requiring an equipment rack. The MP-AMP30 meets the requirements of UL 2043 for installation in an environmental air-handling (plenum) space, such as above a suspended ceiling. High-efficiency Class D circuitry delivers 15 Watts per channel to drive one or two pairs of 8 Ohm speakers, or a single pair of 4 Ohm speakers, making it ideal to support stereo speakers at the front of a room or mono speakers in the ceiling. Mono-summed operation is enabled by changing two jumpers on the front panel. Refined, reliable operation is ensured thanks to pop-free turn-on circuitry and electronic short-circuit and overload protection. An energy-saving design achieves optimum efficiency under load, and the amplifier powers down automatically when no input signal is detected for more than 5 minutes, reducing overall power consumption and heat as part of a green system design. The amplifier quickly powers back on the instant an input signal is detected. Its extruded aluminum housing is both attractive and effective at dissipating heat, affording a silent running design without cooling fans. Installation and setup of the MP-AMP30 is simple. Detachable output connectors facilitate the termination of speaker wiring up to 16 gauge. RCA inputs connect directly to the line output of a video projector or display, audio processor, mixer, or AV switcher. Rotary controls provide for adjusting the overall speaker volume, as well as bass and treble. For quiet environments, loudness compensation is employed by setting the volume control below the center detent position.
Input Volume Range |
-55dB to +20dB |
Loudness |
±15dB @ 100Hz |
Bass Gain Range |
±15dB @ 100Hz |
Treble Gain Range |
±15dB @ 10kHz |
Frequency Response |
20Hz to 20kHz ±0.5dB |
S/N Ratio |
75dB 20Hz to 20kHz A-weighted |
THD+N |
0.7% 20Hz to 20kHz |
Output Power |
15 Watts per channel at 8 or 4 Ohms |
Amplifier Protection |
Electronic short-circuit and overload protection |
Audio Out 8Ω |
- 2-pin 3.5mm detachable terminal blocks; |
Audio In |
- RCA female, unbalanced stereo line-level audio input; |
PWR 24VDC 2.0A |
- 2.1 x 5.5 mm DC power connector; |
Bass |
Rotary low frequency boost/cut adjustment, flat at center detent |
Treble |
Rotary high frequency boost/cut adjustment, flat at center detent |
Vol |
Rotary input level adjustment |
Power |
green LED, indicates operating power supplied from external power pack |
Power Pack |
2.0 Amps @ 24 Volts DC; |
Temperature |
41° to 104°F (5° to 40°C) |
Humidity |
10% to 90% RH (non-condensing) |
Heat Dissipation |
21 BTU/Hr |
HxWxD |
5.85 in (149 mm) x 3.91 in (100 mm) x 1.43 in (37 mm) |
Weight |
11.8 oz (335 g) |