QSC DPM 300/300H

Introduction
Features
Specifications

Introduction

The DPM builds on the legacy of QSC’s DCM and DCP products to provide all signal processing and monitoring functions for Digital Cinema in a single integrated system. Designed to be used with QSC’s Digital Cinema Amplifiers (DCA) and featuring advanced Intrinsic Correction™ settings for QSC’s Digital Cinema Speakers (DCS), the DPM optimizes loudspeaker performance while simplifying cinema sound system wiring and configuration. The DPM 300 is configurable for passive, bi-amp, tri-amp and quad-amp operation and 2 or 4 surround channels (5.1 or 7.1).

Features

Specifications

Introduction
Features
Specifications

Features

Ten digital inputs for 5.1 and 7.1 soundtracks and HI/VI
HDMI input/output for non-sync sources (DPM 300H)
Dolby Digital Plus™ and DTS-HD® (DPM 300H)
Control and monitoring via Ethernet including full SNMP support
Serial automation control via RS-232
Analog Inputs for film processors, non-sync and Mic/Line
Master volume and full 1/3 Octave Graphic EQ on all channels (except subwoofer)
Booth Monitor loudspeaker and headphone jack
Digital Loudspeaker Crossovers — three passive bi-, tri-, or quad-amp screen channels
Compatible with all existing DCA amplifiers — thousands of DCA-equipped screens are ready for full network monitoring and control
Bypass mode routes audio around failed components to insure that the show will go on
Intrinsic Correction™ for DCS loudspeakers for optimal “out of box” performance and reduced set-up time
Continued development of software and firmware will add new capabilities to the existing hardware with easy firmware updates

Introduction

Specifications

Introduction
Features
Specifications

SPECIFICATIONS

Dimensions (HxWxD)	3.5"(2 RU) x 19" x 15"
Line voltage requirements	100 VAC – 240 VAC, 50/60 Hz
Accessories included	6 ft UL/CSA line cord, Connector Kit
LCD	128 x 64 bit Monochrome LCD
Monitor output	3.5 mm TRS
Network RJ45	10/100 Mbps network management
Automation Inputs	RJ45 – 6 contact closure inputs
RS232	DB-9 Serial Interface

Line Inputs	3.5 mm TRS — Stereo Left and Right and Lt/ Rt Matrix
Mic/Line input	XLR — Mic (+ phantom pwr) or line level
Speaker	2"x 3.5" full-range
A/D conversion	24-bit delta-sigma, 48 kHz
Frequency response	20 Hz to 20 kHz (+- .5dB)
Connector	DB25F - 8 channel
Input impedance	20k Ohms
Max analog input level	+14.2 dBu (4.0 Vrms)